Fixed a problem in which an IP address would not appear on the Web GUI if the static IPv4 address was set to a link local address (169.254.0.0/16).Fixed a problem in which authentication may fail if the IP address was set and there was a linked-down VLAN interface in the RADIUS server function.Fixed a problem in which the POWER indicator may not light in orange when an abnormal temperature was detected.The port authorization setting is enabled and it is not in the multi-supplicant mode.Fixed a problem in which a port that satisfied the following conditions could be changed to a trunk port.switchport trunk allowed vlan add VLAN-ID.Fixed a problem in which the switch would not be able to communicate through the native VLAN when launching the switch using a config where either of the following commands was set to the interface.Fixed a problem in which, in rare cases, a LAN port would not be linked-up at the startup.The open-source software license is now shown on the Web GUI help.Enables the SYSLOG functions to output the following INFO level logs when more than one L2MS master is detected or the duplicate is resolved.Addressed the following vulnerability in OpenSSL.

Please note that only the corresponding CIST ports is shown.

Enables the interface gadgets to show port block status caused by the spanning tree protocol on the Dashboard screen of the Web GUI.

Added the Backup / Restoration pages to the Management screen of the Web GUI.

Added the following pages in the Detailed settings screen.Enables using LACP link aggregation with stack configuration.

Yamaha firmware update